共查询到20条相似文献，搜索用时 31 毫秒
1.
MU Long hua 《保鲜与加工》2001,(5):89-92
Fault detection of the distribution systems is one of the key techniques for feeder automation. At all times, it is still very difficult for the exact detection of single phase to ground fault. First of all, the distinguishing rules of the faulted phase are presented when ground fault occurs in distribution systems. This paper analyzes the fault detection technique for single phase to ground in system with floating neutral point. Based on faulted phase's current, a method realizing ground fault protection is proposed and the algorithm model of action criterion is given out. The simulation results show that the method will be with very good selectivity to ground fault, and it can be used preferably in feeder automation. The detection method for short circuit fault is also introduced simply. 相似文献
2.
Considering traditional current protection cannot satisfy the micro-grid, a system protection solution for the micro-grid is proposed. In this solution, the failure message with direction information can be exchanged among the adjacent protection units, so the fault coverage can be determined and the fault can be quickly cleared. By analyzing the movement of the protection in three kinds of fault conditions in the micro-grid that contains three branches and two micro-power based on inverter, the method has been proved that the fault can be quickly cleared and the protection has the same protection strategies for both islanded and grid-connected operation. 相似文献
3.
4.
Application of higher density wavelet transform to composite fault diagnosis of rolling bearing 
下载免费PDF全文
下载免费PDF全文 Aiming at the difficulties in accurate reorganization of several weak faults currently, a composite fault diagnosis method based on higher density discrete wavelet transform and envelope spectrum is proposed. Firstly, the higher density discrete wavelet transform is used to decompose acquired vibration signals of rolling bearings. Then, the single-subband reconstruction is performed on the wavelet coefficients and scaling coefficients at each scale in order to solve frequency aliasing. Finally, the envelope spectra of all subband signals are calculated, and all faults can be recognized according to the characteristic frequencies of the typical faults. The proposed method is applied to the diagnosis of the rolling bearings with composite faults, and is compared with other common fault diagnosis method. The results show that the proposed method can be effectively used for the early composite fault diagnosis of rolling bearings. 相似文献
5.
Based on the study on the properties of Magnetic Inrush Current and Fault Current of power transformers, Saber is applied to realize the simulation of such conditions as no-load closing and all the fault conditions including turn-to-turn fault and turn-to-earth fault. Grounded on the wavelet analysis theory, a new method is proposed which can differentiate effectively the internal and external faults and detect the turn-to-turn fault. The simulation result shows its effectiveness. 相似文献
6.
《保鲜与加工》2003,(10):97-100
It is very difficult to simulate the motion process of drill by accurate mathematics model for the complexity and invisibility of stratum. The fault of drill is usually identified and disposed by personal experience so far. This means it can not estimate the trend of the equipment running good or not and the reason conduced the fault or location and degree of fault by data measured. Farther, it can not give the expert suggestions. Based on the studying of drill fault, artificial intelligence and expert system have been used in the petroleum drilling engineering, the theory and method of fault diagnosis intelligence system for drill have been studied. It also constitutes the expert knowledge database of graphic Fuzzy Neural Network for the familiar fault of drill. The intelligence reasoning machine which consists of expert rule, Fuzzy logic and artificial Neural Network have been bring forward. And the fault diagnosis system it makes for drill can be applied in complex system which includes multi-variable, multi-parameter and multi-process. 相似文献
7.
A novel method for power transmission line monitoring and fault diagnosis is proposed based on non linear frequency response analysis. The power line carrier signal has been used for on line monitoring of power transmission line. As the non linear frequency response function describes the system inherent characterization, different frequency response patterns corresponding to different operation states of transmission line can be established. Based on the analysis of transmission line characteristics of fault modes, various fault features can be extracted, thereby achieve online monitoring and fault diagnosis on transmission line. Simulation experiments show the effectiveness of the proposed method. 相似文献
8.
To solve the problem that the existing method of extracting fault components is easily affected by power system swing,a new methed has been proposed in this paper,which can be used in high speed protection of transmission lines. This proped method ean greatly decrease unbal-ance outputs under power swing condilions without frequency tracking circuits,therefore it can make the protection using fault compnents operate correctly. 相似文献
9.
Addressing the problem of choosing a fault line under single phase to ground of distribution network, we presented a new criterion based on analysis of the development of fault line selection and a method using wavelet packets. The feature frequency band, or the combined feature frequency bands of each line, in which the transient capacity current was concentrated was chosen for maximum energy. Based on the principle that the transient capacity current's energy of the fault line was larger than the that of normal lines, fault line selection can be carried out adaptively by contrasting the energy of the transient capacity currents of all lines in each chosen frequency band. The simulation results and spot testing data shows the proposed method can detect the fault line in distribution networks precisely and reliably. 相似文献
10.
This paper discuses the method with which the corrosion of the grounding grid can be diagnosed .A grounding grid can handled as a circuit network. With the application of circuit network graph theory and the fault diagnosis theory of analog circuit and optimization, the fault diagnosis equations can be set up. This equations is figured out by Matlab, and the corrosion status of the grounding grid can be deduced from the result. 相似文献
11.
Building management control systems (BMCS) are widely employed in modern buildings. The huge amount of data available on central stations and outstations provide rich information for fault diagnosis of HVAC systems. An online fault diagnosis method for variable air volume air handling units was presented using self-tuning HVAC component models. The model parameters are tuned online by using a genetic algorithm (GA) which minimizes the error between measured and estimated performance data, so high modeling accuracy is assured. If the error between measured and estimated performance data exceeds preset thresholds, it means the occurrence of faults or abnormalities in the air handling unit system. The statistical method of selecting thresholds also is presented. The fault detection method was tested and validated using data collected from real HVAC systems. The results of validation show that the fault detection method can be integrated in BMCS systems to detect faults in air handling unit systems efficiently. 相似文献
12.
Lu Jiping Ye Yilin 《保鲜与加工》1988,(4)
So far, the accuracy of the existing methods of fault location based on calculating the impedance at only one terminal of lines is certainly affected by the variation of the system impedance at the remote end. In accordance with parallel lines' special characteristics, this paper presents a method that can calculate the system impedance of the remote end when one of the two lines has fault, so that the effect of its variation can be eliminated completely. This method has been tested by the computer digital simulation, and the results are very satisfactory. 相似文献
13.
Yang Hua Wang Yuhong Ren Zhen 《保鲜与加工》1997,(4):81-86
The properties of fault signals of motors are studied using dyadic wavelets transform in this paper,which can be treated as signals with sigularities.The method of removing white noises is presented by using the difference between the wavelets transforms of white noises and those of fault signals of motors in this paper."Denoised" signals can be reconstructed by using this practical algorithm. 相似文献
14.
DENG Guo-hong~ 《保鲜与加工》2004,(10):8-13
A method of diesel engine fuel system fault diagnosis based on wavelet transform and fuzzy C-means clustering is presented. Five characteristic parameters of reflecting fault state are distilled with wavelet transform of pressure wave of high-pressure oil pipe of diesel. The theory and generic approach of fuzzy C-means clustering algorithm (FCM) is given, and the validity of evaluating fuzzy clustering making use of partition coefficient, partition entropy and parting coefficient is pointed out. Identification of fault mode can be completed utilizing standard fault character modes established by FCM algorithm, and calculating and comparing the similarity degree between this standard mode and sample. The arithmetic is applied to all kinds of typical faults diagnose in the diesel engine fuel system. Measuring results indicate that the precision of fault diagnosis is increased with the analysis of wavelet and FCM. 相似文献
15.
A new de noising method based on parameter optimized Morlet wavelet is put forward. The Morlet wavelet is chosen as the mother wavelet because its shape is similar to the mechanical shock signals. The mother Morlet wavelet is improved by adding two parameters which decide the shape of the mother wavelet in time domain. The added parameters and the appropriate scale parameter for the wavelet transformation are designed by the cross validation method. Finally, the useful components of the signal can be obtained by the improved Morlet wavelet de noising method. The gear fault diagnosis experimental result shows that the proposed method has a good de nosing performance and it is effective in fault feature extraction. 相似文献
16.
The unbalanced nature of 35 kV distribution system due to capacity values is difficult in neutral operation, which can not meet the demand of voltage balance in static state and arc distinct in fault. This paper proposes a new neutral operation as neutral insulation in static state and resonance grounding in fault , along with EMTP simulation acts. Simulation indicates that new neutral operation method can improve lightning withstand level and decrease trip-out rate of grids. 相似文献
17.
An algorithm of fault section diagnosis based on topology identification for distribution networks is presented. By decomposing the topologic matrix which describing the distribution network into two parts,one part only contain the complex coupling factor ,and the other ignore the complex coupling factor. Using this method, the fault zones in distribution network can be identified and isolated efficiently, and the vertexes of the zones can also be identified automatically. This approach adapts to the changefully network structures. 相似文献
18.
Huang Hui Lu Jiping Ye Yilin 《保鲜与加工》1998,(1):27-33
In accordance with the high and extra high voltage long distance transmission line,this paper presents a fault location method based on two terminal information of self synchronous rectification.We adopt the long transmission line model,consider the effect of distribution capacity and can correct the sample phase angle difference in the real time btween two terminals.So that this method can avoid the fault location error owing to asynchronous message on the two terminals.Tested by a lot of simulations,the results are very satisfied. 相似文献
19.
LIANG Xin-yuan~ 《保鲜与加工》2004,(8):75-78
Causality diagram methodology is a probabilistic reasoning, which can be applied to fault analysis. However, it lacks analysis on the importance of failure mode. The importance of failure mode is introduced to develop causality diagram methodology, which is successfully applied in fault analysis of gas explosion in colliery. The study shows that causality diagram based on importance of failure mode is an effective qualitative and quantitative method to analyse faulty, evaluate system safety and provide feasible countermeasures to prevent accidents. 相似文献
20.
As a kind of complex power machinery, diesel engine is being paid more and more attention to its condition monitoring and fault diagnosis technology. In the fault diagnosis field of diesel engine, the technique of signal process, character abstraction and identification method have formed a system, but there is a certain distance away from practical. This paper analyzes the common faults and influencing factor of diesel engine. The principle, characteristic and disadvantage of modern fault diagnosis technology, such as various time-frequency methods based on vibration signal, speed fluctuation method, iron content and spectrometry, grey system theoretical diagnosis method, artificial neural network and expert system fault diagnosis method, were reviewed. The difficulties and the development direction of diesel engine fault diagnosis were put forward in the end. 相似文献