共查询到20条相似文献，搜索用时 15 毫秒
1.
A creative test method for post-tensioned prestressed frame is presented in this paper. In the test, the stationary supports at the column base are simulated and the forces at the column base can be tested while the two column bases are not connected with concrete beam. The prestressed secondary moment and the weight-produced moment are established by adjusting the support device at the column base. In this paper, the necessary conditions of the method and the basic process are recommended. It is proved theoretically that the prestressed concrete frame built by this method is equivalent to that used in practice. 相似文献
2.
By the experimental study on a full-dimensioned prestressed frame of two spans, the relative factors are analyzed such as relative height of equivalent compression zone in critical section, secondary moment, ratio of beam rigidity to column and development of cracks in the top of columns etc., which influence the moment distribution of the post-tensioned prestressed concrete frame from the side of internal force redistribution. It is believed that that the factors of relative height of concrete equivalent compression zone and secondary moment influence the moment modulation in most degree, and ratio of column rigidity to beam also plays a part in the moment modulation to some extent. Second, the plastic joints of frame with excessive spans exit in the span which endure the whole load, at last the whole frame is destroyed because of the destruction of the loading frame, the influence to the non-loading span is little. 相似文献
3.
The moment modulation of prestressed concrete frame has some differences compared with that of continuous beam.Based on the analysis of ratio of column linear rigidity to beam one,form of load,second moment and plastic hinge in column,this paper is intended to get some helpful advise for moment modulation design. 相似文献
4.
In this paper, the energy method has been used to study the change of the secondary moment of unbonded prestressed concrete continuous beams and it has been contrasted with bonded prestressed beams. The question, whether the secondary moment changes or not while loading, was answered. It shows that the primary secondary moment does not change when increment method is adopted to study the beams, but the total secondary moment will change while the force in prestressed reinforcement changes. 相似文献
5.
Jian Bin Wu Hong Wang Zhenglin 《保鲜与加工》1998,(6):38-43
A test method of post-tensioned prestressed concrete continuous beam is presented in this paper.In the test,the prestressed secondary moment is established by adjusting middle support height.The prestressed concrete continuous beam built by the method is equivalent to the beam in practice. 相似文献
6.
Based on the experimental study of two prestressed frames in redistribution of Internal force, it can be concluded that the dominating influence factors on moment modulation are the relative height of equivalent compression zone, the secondary moment, the ratio of beam rigidity to column and development of cracks in the top of columns.The secondary moment is very important in modulation of frames. Especially, the secondary moment will governing the modulation when the relative height of equivalent compression zone is large enough. 相似文献
7.
Around the reconstruction design of the Popular Science Image Building of the Southwest Hospital, the advantage of prestressed concrete frame used in the rebuilding was approved. At the same time, the problem in the prestressed frame design was pointed out. In the end, the method to decrease the moment in the column had been put forward. 相似文献
8.
Jian Bin Wang Zhenglin Bai Shaoliang 《保鲜与加工》1999,(2):12-18
Based on the information from China and overseas,a design suggestion for moment modulation of post-tensioned prestressed concrete continuous beams with bond has been put forth in this paper. The result calculated by the suggestion is consistent with the result of varying rigidity method. 相似文献
9.
By the way of experiment and analysis of two "one story and one bay" reinforced concrete frames, namely a "beam with weaker column" frame and a "column with equally strong beam" frame, the features of internal force redistribution are investigated and an elementary comparison about bending moment redistribution of three kinds of frames namely the "column with weaker beam", "beam with weaker column" and "column with equally strong beam" is given. Through this comparison, the objective existence of such "three kinds of frame" is proven, the moment redistribution is different for each frame and for the moment modulation, the elastic moment diagram and the difference of the internal force redistribution in different frames should be considered together. 相似文献
10.
In this paper, based on the structure characters and load applying means, a method called as curvature force method is put forward and proved in the nonlinear analysis of bonded prestressed concrete frame. Based on the nonlinear program, the simulation calculation was carried out on test results of two prestressed concrete frames by this method. The results from calculation are identical with the experiment ones. So it may be added to the methods for the nonlinear analysis of prestressed concrete frame. 相似文献
11.
"Strong column with weak beam","strong beam with weak column" and"column & beam with equal strength"can be existed in one-storey prestressed concrete frames and the top storey of mult-storey prestressed concrete frames.Through the test of four prestressed concrete frames under vertical load,three kinds of prestressed concrete frames performances are studied,such as ultimate load,deflection,displacement ductility,redistribution of internal force.When the relative height of equivalent compression zone is smaller enough,the test proves that three kinds of prestressed concrete frames can realize full redistribution of internal force and have better displacement ductility,the width of cracks and deflections can satisfy the rules of code for design of concrete structures. 相似文献
12.
Zhou Jiyue Zeng Qingyu 《保鲜与加工》1991,(3)
Through the static tests of five two-span continuous beams with a relatively small steel ratio, the regularity of redistribution of internal forces of continuous beams with moment modulation is studied, and the moment modulation influence on cracking and deflection of continuous reinforced concrete beams under service loads is analyzed in detail. The conclusions obtained may be used as reference materials for drafting of design code considering redistribution of internal forces. 相似文献
13.
Based on the project of a prestressed concrete beam-slab structure,this paper introduces the optimum design of a four-spanned exceedingly long prestressed floor. Different schemes,such as the scheme of the prestressed major beam,the scheme of the prestressed secondary beam with the same span and the scheme of the prestressed secondary beam with different spacing,are compared and analyzed in this paper.Meanwhile,various methods of the exceedingly treatment for long prestressed reinforcement are compared.Finally,based on two prestressed beams,the prestress loss,the prestressing value at the ends of the beam and the deflection in the midspan of the beam are detected during the tension and anchorage stage in order to verify the results of the theoretical analysis. 相似文献
14.
Taking a two-lane extra large bridge as sample,it is to analyze the real time thermal field and thermal effect on a long-span prestressed concrete box girder. The obtained data is compared with the simulation which is based on a balancing theory of temperature distributions and exchange in box girder exterior surfaces. The results show that the proposed method can emulate the actual boundary conditions precisely, it can satisfy the design analysis requirement of the practice engineering. Based on the emulation of the temperature field, with the ANSYS secondary development technology, FEM modules are developed to analyze the thermal field of the prestressed concrete box girder bridges. The present examples show that the developed modules are effective and useful. 相似文献
15.
In this paper, a study is carried out on large-span prestressed concrete structure system in residence analyzed by specially - shape column equivalent frame model. Applying fiber model column-beam element and shell element, a large amount of comparative analyses about large-span prestressd concrete structure under horizontal and vertical load is carried out. The parameter of the equivalent frame is confirmed based on comparison with the result of the man-sized structural experiment. It is proved that the equivalent frame model has high efficiency and precision especially for nonlinear analysis. 相似文献
16.
In this paper,six reinforced concrete beams dismounted from their worksites under long-term sulphate attack are studied.The authors analyzed the working properties and cracking moment of the reinforced concrete beams under long-term sulphate attack,suggesting that the reinforced concrete beams under long-term sulphate attack may have more favorable cracking-resistant behavior in some circumstances. 相似文献
17.
在梁侧或梁底用波形齿横向张拉CFRP片材并锚固的体外预应力加固混凝土结构技术,对3根完全相同的7 m跨T形截面梁进行加固：其中2根梁侧面加固;1根梁底部加固。试验表明：多点锚固体外无粘结CFRP预应力可以依据构件的弯矩来调整各段的加固量从而更有效的利用CFRP材料的高强性能;梁底与梁侧加固对提高构件的抗弯刚度差别不大;波形齿能彻底解决预应力CFRP片材的锚固问题。以该3根加固梁的试验结果为基础,提出了梁体极限状态下塑性绞区长度的体外无粘结预应力碳纤维加固受弯构件的抗弯承载力公式,以及考虑二次效应的有效惯性矩法的挠曲变形的计算公式,通过与试验值的对比分析可知,所提出的方法可供设计参考使用。 相似文献
18.
For prestressed frames, the axial compression ratio will affect not only the ductility of structures but also the structural internal force.Based on the computer-calculation for four groups of 24 prestressed frames combined with the references, in this paper, the effects of axial compression ratio on the prestressed frames are studied and discussed through three aspects: the second-order effect, the axial deformation of frame-columns and the comparison with ordinary concrete frames.The study results show that the effects of axial compression ratio on the prestressed frames and the ordinary concrete frames are basically consistent, but there are some self-born characteristics.As a whole, the effect of axial compression ratio on the prestressed frames is more notable than that on the ordinary concrete frames, but under common situation the effect is small. 相似文献
19.
Deng Chaorong Niu Shaoren 《保鲜与加工》1989,(4)
In this Paper,multistoryed buildings of brick and RC floor slab construction are put up on frame beam of 12. 6 m partially prestressed concrete.A test and analysis is carried out on site.It provides a new scheme for multisto-reyed and highrise buildings with beam of transitive force and transfer floor. 相似文献
20.
It provides several typical mega plane frame designs on condition that the variables are the combination of varying amplification factors of moment at bottom sections of ground floor columns of the minor frame on the major beams. The elastic-plastic dynamic analysis program Drain-2d+ of the plane structure is used to get elastic-plastic time-history analysis for each typical mega frame under the action of seism. The autuors obtain the information of the mechanical transmutation characteristics, the emergency of the plastic hinge and the weak point of the whole structure under the action of seism, from which the correct thinking of how to obtain the design value of amplification factors of moments at bottom sections of ground floor columns of the minor frame on the major beams is found. The reasonable design values are recommended in order to provide some suggestions for the design of the reinforced concrete mega-frame structure. 相似文献