共查询到20条相似文献，搜索用时 78 毫秒
1.
用ＵＦ、ＭＵＦ胶制作三种松木胶合板，分别就单板厚度、涂胶量及抽提物含量对胶合性能的影响，松木与柳安混合树种组坯、特殊添加剂对改善胶合性能的作用进行了研究。结果表明：除了老挝松边材ＭＵＦ胶合板以外，１．５和２．０ｍｍ厚的单板胶合强度均达到或超过日本ＪＡＳ普通胶合板的要求。合板胶合强度随单板厚度增加而下降，在一定范围内增加涂胶量可以提高合板胶合强度，混合组坯及施加特殊添加剂具有改善松木单板胶合性能的作用。 相似文献
2.
3.
4.
影响阻燃胶合板胶合强度因素的研究 总被引：2，自引：1，他引：2
分析了使用BL-环保阻燃剂压制环保阻燃胶合板过程中,热压温度、热压时间、单板浸渍时间和涂胶量对胶合强度的影响,并检测了氧指数、甲醛释放量和含水率。研究表明,使用BL-环保阻燃剂生产环保阻燃胶合板可以达到胶合强度标准,并提出了最佳工艺条件。 相似文献
5.
高频加热弯曲胶合新工艺 总被引：3，自引：0，他引：3
高频加热弯曲胶合是一项较新的工艺,它包括单板准备、涂胶配坯、热压成型等过程。本文主要概述了这一工艺的特点,高频加热和弯曲胶合成型的原理与设备、工艺流程和主要的工艺技术参数。 相似文献
6.
改性豆基蛋白胶黏剂的胶合工艺初探 总被引：2，自引：0，他引：2
以杨木单板为试材研究了改性豆基蛋白胶黏剂的胶合性能,采用单因素实验方法,探讨了改性豆基蛋白胶黏剂压制胶合板的胶合工艺。分析了热压温度、热压时间和涂胶量对三层杨木胶合板胶合性能的影响。结果表明:采用改性后的豆基蛋白胶黏剂,在压力为1.4MPa,温度为165℃左右,热压时间为1.4～1.6 min/mm,涂胶量为220g/m~2,压制的杨木胶合板胶合性能较佳且达到Ⅰ类胶合板的标准。 相似文献
7.
8.
涂胶量对胶合强度的影响 总被引：1，自引：0，他引：1
本文通过实验数据的整理,绘制出在一定工艺条件下桦木、柳桉、山樟三个树种胶合板的涂胶量与胶合强度的关系曲线,由此提出临界涂胶量的概念。同时对涂胶量、热压压力和胶合强度、木材压缩率进行研究,提出在胶合板生产中确定合理涂胶量值的方法,以保证在取得合格的胶合强度的同时,达到降低成本的目的。并对临界涂胶量值进行了理论分析。 相似文献
9.
10.
11.
《Scandinavian Journal of Forest Research》2012,27(5):427-435
In Scandinavia, moose (Alces alces L.) sometimes cause severe browsing damage to economically-important pine. Moose-vehicle accidents have spurred construction of fences along roads, and these may interfere with moose migration between summer and winter ranges, or the road alone may be a barrier. If this happens and moose build up along roads, landowners may suffer economically. Therefore, this study investigated whether roads, fences or other factors influence the use of young pine stands by moose. Eighty stands along roads in northern Sweden were evaluated in which individually-browsed branches were counted on 9972 pines. Moose browsing was not significantly related to birch (Betula pendula Roth, B. pubescens Ehrh.) density, nor did it differ between pines (Pinus contorta Douglas or P. sylvestris L.). However, increased pine density, site productivity and proximity to a highway were associated with increased browsing. Further large-scale studies are needed to understand moose habitat selection and the effects of roads. 相似文献
12.
《Scandinavian Journal of Forest Research》2012,27(3):206-217
The root systems of 2-yr-old Picea glauca, Picea mariana and Pinus banksiana seedlings were submitted to various frost temperatures during an artificial frost to induce different levels of root damage. Frost-damaged and control seedlings were placed in a greenhouse under high and low soil moisture regimes. Seedling growth and physiology were evaluated periodically. Seedling survival was reduced when root damage reached levels of 60-80%. Root systems of all three species showed partial to total recovery by the end of the experiment. In general, root freezing damage caused reductions in seedling growth, with these reductions becoming less significant over time. Root damage had little to no effect on black spruce and jack pine seedling physiology, while white spruce CO 2 uptake decreased with increasing root damage. Shoot nitrogen content of all three species decreased slightly with increasing root damage. 相似文献
13.
《Scandinavian Journal of Forest Research》2012,27(1):53-61
This study investigated the stand structure in pine, spruce and deciduous forests in the border district of Finland and Russia. A total of 46 mature forest stands was selected as pairs, the members of each pair being as similar as possible with respect to their forest site type, age, moisture and topography. The stands were then compared between the two countries by means of basal areas and number of stems. The proportions of dominating tree species were 2-12% lower, and correspondingly the proportions of secondary tree species higher, in Russian forests. The density of the forest stock was also higher in each forest type in Russia. The forests in the two countries differed most radically in terms of the abundance of dead trees. The amount was two to four times higher in Russian deciduous and spruce forests, and in pine forests the difference was 10-fold. The stand structures indicated that Russian coniferous stands, in particular, were more heterogeneous than intensively managed pine and spruce stands in Finland. 相似文献
14.
《Scandinavian Journal of Forest Research》2012,27(1):15-27
The root collar diameter and the height:diameter ratio are of particular importance in container-grown seedlings where a high density in the containers may produce spindly seedlings. Temperature regimes and light quality are known to affect plant growth. The aim of this study was to identify responses in Picea abies (L.) Karst. seedlings grown with light providing different red:far-red ratios and under temperature regimes with alternating day (DT) and night temperature (NT) from negative (DT < NT) to positive (DT > NT) difference (DIF) between DT and NT. Experiments were conducted in controlled environment chambers and in a daylight phytotron. Only limited thermoperiodic responses appeared in P . abies seedlings with respect to seedling height and dry weight accumulation. The formation of terminal buds, however, was clearly delayed in seedlings grown at negative DIF. The results indicate a requirement for day extension light that is high in far-red, to prevent terminal bud formation under natural short-day conditions. An extended study should be conducted to clarify the minimum level of light intensity and the optimal light quality needed to prevent terminal bud formation under natural short-day conditions. 相似文献
15.
本文分析了CAD在设计中引起的正面和负面影响,并进行了系统的阐述,从而使设计者在应用中能够保持客观的态度。 相似文献
16.
《Scandinavian Journal of Forest Research》2012,27(2):131-138
The effects of soil scarification (mounding), slash removal and clear-cut age on the natural regeneration in clear-cuts was evaluated using data from four sites in southern Sweden. The treatments were carried out during a good seed and establishment year for birch ( Betula pubescens Ehrh. and B. pendula Roth). Scarification had the strongest positive effect on the density of naturally regenerated seedlings, especially in birch, but also in pine ( Pinus sylvestris L.) and spruce [ Picea abies (L.) Karst]. Slash removal had a positive effect on birch density. No statistically significant effect of clear-cut age was found. In addition, no statistically significant interactions between clear-cut age and scarification or slash removal were found. The ingrowth of field vegetation was the fastest in areas that were not scarified, less rapid in areas scarified on old clear-cuts, and the slowest after scarification in fresh clear-cuts. In conclusion, it may be possible to control the density of birch during a good establishment year for birch. If birch is desired, the best combination of treatments is to remove the slash and scarify; otherwise, these treatments should be avoided. 相似文献
17.
18.
《Scandinavian Journal of Forest Research》2012,27(5):472-479
Based on an enquiry, risk perception among non-industrial private forest owners is described in relation to climate change and forestry hazards. Of the respondents, 11% took action to remedy the effects of climate change. Out of a given set, hazards were ranked according to each respondent's experience of recent substantial financial loss to the estate and in relation to his or her willingness to make investments aimed at risk reduction. For each hazard, the respondent assessed the risk in four classes ranging from very high to negligible risk. Six hazards were considered most problematic in all three aspects: browsing damage, falling timber prices, damage by wind, spruce bark beetle, root rot and pine weevil. A majority of the respondents claimed to take action to reduce the risk associated with at least one hazard, while 35% did not know whether they did. Excluding climate change, the need for decision support was the largest in relation to damage by wind owing to a combination of perceived high risk and a high level of ignorance in relation to whether risk-reducing measures were taken. 相似文献
19.
Srisuda Thippayarugs Banyong Toomsan Patma Vityakon Viriya Limpinuntana Aran Patanothai Georg Cadisch 《Agroforestry Systems》2008,72(2):137-148
In situ produced plant residues contain a mixture of different plant components of varying quality. To assess synergistic
or antagonistic interactions occurring during the decomposition and mineralization of such mixtures, individual plant parts
(stems, leaves, leaf litter and roots) or the mixture of stems, leaves and leaf litter of the agroforestry species pigeonpea
(Cajanus cajan) or of crop residues of peanut (Arachis hypogaea) or of the weed hairy indigo (Indigofera hirsuta) were incubated in pots for 19 weeks. Periodically, remaining plant residues were sieved out (>2 mm), weighed and N content
as well as soil mineral N determined. Above- and below-ground residues of peanut decomposed fastest and showed the largest
N release in agreement with their high N concentration and low-acid detergent fibre (ADF) : N ratio. Hairy indigo was hypothesized
to be of lower quality than pigeonpea because of its high-polyphenol content. However, it decomposed faster than pigeonpea,
largely because of the higher N and lower lignin concentration of its components. Ranking of individual plant components for
N mineralization resulted in the following pattern, leaves > leaf litter > roots > stems. In mixtures of the different plant
components a similar species order in decomposition was obtained, e.g. peanut > hairy indigo > pigeonpea. The amount of N
released from the mixture was dominated by stem material that comprised 46–61% of the mixture. The interactions in mixtures
were relatively small for peanut (generally high-quality components) as well as for pigeonpea (low proportion of high-quality
components, i.e. N rich leaf material). However, a positive interaction occurred during later stages of N mineralization in
the mixture of hairy indigo as it had a significant proportion of N rich components and absence of highly reactive polyphenols.
Thus, for plants with low to intermediate chemical quality attributes, manipulating plant composition (e.g. by varying harvest
age, affecting stem and leaf proportions) will be important to obtain significant interactions during decomposition when its
components are mixed. 相似文献
20.
A. Rigueiro-Rodríguez M. R. Mosquera-Losada E. Gatica-Trabanini 《Agroforestry Systems》2000,48(3):245-256
The use of organic waste materials such as milk sewage as an organic fertilizer could have the dual advantages of organic-waste
disposal and reduced dependence on inorganic fertilizers. The effects of fertilization with (1) conventional mineral fertilization,
(2) milk sewage sludge at 40 kg N ha−1 target rate and (3) no fertilization on pasture production and tree growth were examined in an experiment consisting of two
pasture mixtures under a one-year-old Pinus radiata plantation with a density of 2500 trees ha−1. The two pasture mixtures were: (1) Dactylis glomerata L. var. saborto (25 kg ha−1) + Trifolium repens L. group Ladino (4 kg ha−1) + Trifolium pratense L. var. Marino (1 kg ha−1); (2) Lolium perenne L. var. Tove (25 kg ha−1) + Trifolium repens L. group Ladino (4 kg ha−1) + Trifolium pratense L. var. Marino (1 kg ha−1). The experiment began in the spring of 1995 using a randomized block design with three replicates in Castro Riberas de Lea
(Lugo, Galicia, north-western Spain). Plot size was 12 × 8 m2, with a 1 m buffer strip between plots. Two-year data showed that fertilization with either material had a positive effect
on pasture production, with no significant difference between the two fertilization treatments. Tree growth in the milk sewage
sludge plot was significantly higher than in the control plots. Inorganic fertilization increased pasture production, but
affected tree growth negatively. The results show that milk sewage sludge could be used as a fertilizer in silvo-pastoral
systems.
This revised version was published online in June 2006 with corrections to the Cover Date. 相似文献