蒸发浓缩－CODcr法测定地面水中低浓度COD     

傅一穷 《浙江大学学报(农业与生命科学版)》1996,(5)

对水样蒸发浓缩法用于地面水中低浓度ＣＯＤ的测定进行探讨的实验结果表明，地面水中低浓度ＣＯＤ物质可以在碱性条件下，通过蒸发浓缩处理后，采用重铬酸钾法进行测定，所得结果的精密度和准确度良好．若选择水样浓缩系数为５，则可将重铬酸钾法的最低检测限浓度降低到１０ｍｇ·Ｌ－１，从而使该方法能够适用于地面水水质标准中各类水质ＣＯＤ的监测要求．  相似文献   

甲醛捕捉剂在胶合板生产中的应用   总被引：7，自引：0，他引：7  

胡炬亮  龚颖峰  王禹胜 《木材工业》2005,19(1):35-36

普通UF树脂胶中添加甲醛捕捉剂H300或H800后,其固化时间明显延长.采用H300或H800改性的UF醛树脂胶黏剂生产胶合板,在保证胶合强度的前提下,板材的甲醛释放量达到国标E2或E1级要求.  相似文献   

改善E1级胶合板用UF胶粘剂预压性能的研究   总被引：1，自引：0，他引：1  

焦德贤  唐朝发 《吉林林业科技》2005,34(5):45-47

利用氧化淀粉在树脂合成后期、API在调胶时加入分别对脲醛树脂进行改性，探讨改性UF对胶合板预压强度的影响。采用正交实验法对比改性后胶合板的预压性能和改性后胶合板的甲醛释放量的变化。结果表明：随着API量的加大，胶合板的预压性能得以提高；而氧化淀粉改性后则随着量的加大，一定范围内胶合板的预压性能得以提高，加入量继续加大后反而下降。  相似文献   

非平行直纹面的电解磨削     

干为民  褚辉生苏纯 徐家文 《勤云标准版测试》2005,(3):216-223

为解决整体叶轮扭曲叶片型面的精加工难题,本文进行了五轴联动数控展成电解磨削的基础研究.在分析平行直纹展成电解磨削整体叶轮扭曲叶片的过切误差、得到过切误差计算公式的基础上,提出用圆锥磨轮和组合式五轴联动数控方案来消除过切误差的方法.文中还介绍了数控展成电解磨床的结构与运动、经济型多轴数控系统及其联动控制方法,并建立了电解磨削非平行直纹展成曲面的数学模型,开发了五轴联动数控展成电解磨削自动数控编程系统,对航空发动机整体叶轮的叶片型面进行电解磨削.结果表明,加工效率比手工修磨、抛光提高了12倍以上.  相似文献   

Influence of death struggle on the structural changes in chub mackerel muscle during chilled storage     

Masashi Ando  Masao Joka  Satoshi Mochizuki  Koh-Ichi Satoh  Yasuyuki Tsukamasa  Yasuo Makinodan 《Fisheries Science》2001,67(4):744-751

ABSTRACT: Chub mackerel (34–35 cm, approximately 500 g), which were caught by fishing with a rod and line at the Bungo Channel, Oita prefecture, were rested overnight in a fish preserve and either killed by decapitation (control group) or allowed to struggle in air for 30 min (struggled group). Muscle samples were excised every 4 h, and measurements on breaking strength and histological observations were done for both groups. The breaking strength of muscle in the control group was significantly higher than that in the struggled group, whereby a decrease in breaking strength was delayed for 12 h compared to the struggled group. Light microscopy showed space extension among muscle cells in association with a decrease in breaking strength. Especially in the struggled group, the extended area was larger and the difference in area was significant at the time when breaking strength showed a significant difference. Using electron microscopy, the extended area showed cut and/or disappeared collagen fibrils. From these results, it was demonstrated that struggling to death promoted the degradation of collagen fibrils and the weakening of connective tissue and, resultantly, led to the faster softening of muscle of chub mackerel.  相似文献   

Application of acoustic Doppler current profiler combined with a scientific echo sounder for krill Euphausia pacifica density estimation     

Kyounghoon  LEE  Tohru  MUKAI  Donhyug  KANG  Kohji  IIDA 《Fisheries Science》2004,70(6):1051-1060

ABSTRACT:   An application of the acoustic Doppler current profiler (ADCP, 153.6 kHz) in combination with a scientific echo sounder (EK60, 38 and 200 kHz) was investigated to estimate the density of krill Euphausia pacifica . The acoustic backscattering strength from sound scattering layers was compared with biomass estimates from midwater trawls. Euphausia pacifica was targeted among mixed species populations in the sound scattering layer in the offshore Funka Bay area of Hokkaido, Japan. The frequency characteristics of acoustic backscattering by krill were calculated using a distorted wave Born approximation scattering model at three frequencies. Krill aggregations identified from the EK60 data were extracted as the mean volume backscattering strength difference between two frequencies. They were then used to identify similar aggregations in the ADCP data by matching observation times and depths for the two methods, which were applied simultaneously. Results from the comparison of the mean volume backscattering strength and the density calculated from the ADCP and EK60 showed that ADCP can be used to measure density and spatial–temporal distribution of krill aggregations. Current speed and direction at the study site were found to be 16.1 cm/s and 187.0°, respectively, and krill speed and direction (including the current component) were found to be 19.8 cm/s and 172.2°, respectively. Based on the ADCP data, the net speed and direction of the krill aggregations were found to be 5.9 cm/s and 128.0°, respectively.  相似文献   

纤维板表面粉末涂料的涂饰工艺     

门全胜  张文标  李文珠  范增霞 《浙江林学院学报》2004,21(4):437-441

研究一种在纤维板表面进行粉末涂装再转移印花的新工艺.结果表明:纤维板粉末涂装基材预处理采用预热干燥,表面砂光,控制含水率为6%～8%;喷涂上粉量为333.33～388.89 g·m-2;固化条件为180 ℃,15～25 min.采用干燥箱中热转移方式,转移印花温度为(160±10)℃,时间15～20 min.按GB/T 4893-85和GB/T1733-79测试涂膜性能,涂膜附着力等级为2级,耐磨性等级为1级,耐水性合格,耐液性等级为1级.图1表4参9  相似文献   

1QJ-120型浅松机的研究设计   总被引：1，自引：1，他引：0  

孔德军  王世学  高焕文  陈君达 《农机化研究》2004,(2):126-130

针对旧式浅松机表土作业中秸秆和土壤侧向位移问题,分析和优化了浅松机的技术参数,设计了一种新型的1QJ-120型浅松机。该机适用于旱作保护性耕作播前作业,能够达到除草、整地和提高地温等目的,也可以用于中耕除草作业。  相似文献   

Evaluation of Five Most Commonly Grown Cotton Cultivars (Gossypium hirsutum L.) Under Mediterranean Conditions: Productivity and Fibre Quality     

C. Avgoulas  L. Bouza  A. Koutrou  S. Papadopoulou  S. Kosmas  E. Makridou  P. Papastylianou  D. Bilalis 《Journal of Agronomy and Crop Science》2005,191(1):1-9

Studies were conducted in four regions of central Greece (Larisa, Karditsa, Livadia, Thiva), to evaluate the productivity and fibre properties (fibre strength and fibre length) of the five most commonly grown cotton cultivars in these regions. The experiments lasted for 6 years (1995–2000). All the characteristics tested were strongly influenced by the factors ‘year’, ‘cultivar’ and ‘region’. Significant cultivar × region, year × cultivar, region × year and cultivar × region × year interactions occurred for all the characteristics studied. The cultivar Alegria had the highest seed‐cotton and lint yield, while Aria had the lowest ones. Both cultivars gave the highest mean lint percentage but the lowest mean boll weight (MBW). Alegria had the lowest fibre strength, while Aria had the highest. The Acala‐type cultivars, Acala SJ2 and Zeta 2, had intermediate seed‐cotton and lint yield, while Vered 171 had high seed‐cotton and satisfactory lint yield. The three cultivars mentioned above had the highest MBW and very good fibre strength. Positive correlation was observed between fibre strength and length. In spite of the fact that mean fibre length was statistically the same in all cultivars, it was influenced by the factor ‘year’, as a result of different weather conditions. The year 1996 was the most unfavourable one for seed‐cotton yield and MBW, because it was characterized by lower than average air temperatures and rather dry conditions for all study sites. The factor ‘region’, a combination of different climatic conditions and cultural practices, influenced significantly all the parameters studied.  相似文献   

室内型胶合板天然耐久性的初步研究     

吕斌  付跃进  吴盛富  杨帆 《林产工业》2004,31(4):17-20

作为一项反映材料优劣的重要的评价指标,天然耐久性直接决定了材料的使用寿命.笔者通过对胶合板胶合强度性能连续14年的跟踪测定,讨论和分析了胶合板的天然耐久性.最后总结出了胶合板在使用过程中随时间迁移其胶合强度性能随外界变化的规律,以期为胶合板的生产制备、生产工艺的改进及其应用领域的拓宽等方面起到一定的指导作用.  相似文献