排序方式： 共有3条查询结果，搜索用时 31 毫秒
1
1.
With regard to the long span continuous composite beams, the early composite shear stud strength at the joint surface between the steel girder and concrete slab at different concrete ages should be considered while the concrete slabs are casted by phases in construction stage. In this study, the push-out test of stud shear connectors were conduced at different concrete ages. Meanwhile, the change law of the ultimate shear strength, ultimate slip deformation, design shear strength, and shear stiffness of the stud shear connectors with concrete ages were analyzed, and the corresponding time-dependent calculation equations were presented. The results include that the main failure modes of stud shear connectors are the concrete slab splitting failure before 3-days concrete age. The load-slip laws of stud shear connectors at different concrete ages are basically the same, however, the shear strength and stiffness all increase with the concrete ages prolonging, and the increase degree is faster at early ages, but slower at later ages, which indicates that the early composite shear stud strength at the joint surface of composite beams should not be neglected. 相似文献
2.
Four series stud push-out specimens were conducted to study static mechanical behavior when stud shear connectors of composite beams were corroded. Firstly, the studs were manually rapidly corroded by electrochemical methods, and then a static load test was performed on them. Test results show that when corrosion occurs at stud rod especially close to combined surface, the ultimate bearing capacity reduces most by 18%, slip under the same load increases, and slip relative to the ultimate load reduces most by 12%. When corrosion occurs at the large end of stud, it has little effect on ultimate bearing capacity of push-out specimens, but deformation performance of stud shear connectors is affected seriously. 相似文献
3.
《Wood material science & engineering》2013,8(2):76-84
Abstract Wood in general and wooden studs in particular are often distorted owing to uneven shrinkage during the drying process in the sawmill. Twist is often the most detrimental of all types of distortion, and it is caused by spiral grain in combination with variations in moisture content. For sawmills, the objective is to produce dried, straight boards, and one method of dealing with boards with excessive spiral grain is to sort them out and then dry them in a pretwisted position to obtain straight boards after drying. A model using the finite element (FE) method for the simulation of drying twist distortions was first calibrated against laboratory experiments in which boards were dried with and without restraints and pretwists. After the calibration, the FE results were compared with industrial test results for boards that were dried without restraints or with restraints with zero pretwist, i.e. straight restraints. The FE model used an elastic–ideally plastic material model to obtain permanent deformations. The calibration was to set the yield stresses so that there was a good match between FE results and results from the laboratory experiments. The comparison between the industrial test results and the FE results showed that the FE model is capable of realistic simulations of drying boards with and without restraints and presumably also pretwists. 相似文献
1