首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   2507篇
  免费   115篇
  国内免费   409篇
林业   465篇
农学   244篇
基础科学   503篇
  403篇
综合类   787篇
农作物   158篇
水产渔业   54篇
畜牧兽医   262篇
园艺   74篇
植物保护   81篇
  2024年   18篇
  2023年   47篇
  2022年   86篇
  2021年   117篇
  2020年   118篇
  2019年   122篇
  2018年   77篇
  2017年   140篇
  2016年   175篇
  2015年   148篇
  2014年   182篇
  2013年   160篇
  2012年   215篇
  2011年   194篇
  2010年   115篇
  2009年   129篇
  2008年   128篇
  2007年   127篇
  2006年   108篇
  2005年   98篇
  2004年   84篇
  2003年   96篇
  2002年   63篇
  2001年   35篇
  2000年   30篇
  1999年   38篇
  1998年   30篇
  1997年   20篇
  1996年   21篇
  1995年   23篇
  1994年   17篇
  1993年   17篇
  1992年   9篇
  1991年   8篇
  1990年   5篇
  1989年   6篇
  1988年   9篇
  1987年   4篇
  1986年   5篇
  1985年   2篇
  1983年   1篇
  1981年   1篇
  1980年   2篇
  1977年   1篇
排序方式: 共有3031条查询结果,搜索用时 15 毫秒
1.
为探明长江中游玉米籽粒机械直收适宜品种与配套农艺措施,2018—2019年选用不同玉米品种,测定不同机收时间下玉米关键农艺性状、产量及机收质量指标。结果表明,收获时间对春玉米机收产量与机收质量均有显著影响。延迟1周收获后籽粒容重显著增加,机收产量显著提高,2年平均提高9.72%;而延迟2周收获则有降低机收产量的趋势。2年收获时杂质率总体≤3%,而机收籽粒破碎率与损失率均>5%,是该区域春玉米籽粒机收面临的主要问题。籽粒厚度、籽粒含水率和百粒重是影响机收籽粒破碎率的关键性状,三者与机收籽粒破碎率均呈显著的倒二次曲线关系;玉米的倒伏率、穗位高和重心高度是影响机收损失率的关键性状,倒伏率与机收损失率呈显著正相关,而穗位高和重心高度与机收损失率均呈显著的二次曲线关系。延迟收获能显著降低籽粒含水量,从而降低籽粒破碎率,但继续延迟收获有增加倒伏的风险。综上,长江中游春玉米成熟后适时延迟7~10 d收获,可有效降低籽粒含水量与机收籽粒破碎率,提高玉米籽粒机收产量。  相似文献   
2.
不同秧龄对沿江地区双季晚稻秧苗素质及产量的影响   总被引:1,自引:0,他引:1  
以早熟高产品种上农粳2号和镇稻18为材料,采用常规毯苗机械栽插,分别设置20 d、24 d、28 d、32 d等4个秧龄处理,研究不同秧龄对沿江地区双季晚稻秧苗素质、生育进程、茎蘖动态及产量构成的影响。结果表明,随秧龄天数增加,参试品种的绿叶数、茎基宽和根系盘结力均逐渐升高;与20 d、24 d和28 d秧龄的处理相比,32 d秧龄处理的成熟期提前4~5 d,茎蘖高峰期提早15 d左右,结实率显著升高;与24 d秧龄处理相比,上农粳2号和镇稻18在32 d秧龄处理下的产量分别提高10.26%和20.82%。在秧苗强化化控和苗床管理的条件下,安徽沿江地区常规毯苗机插的栽插秧龄可延长至32 d。  相似文献   
3.
本文根据具体机器动作协调性要求及其具体空间几何条件,采用了摆动从动件盘形凸轮机构。其摆杆推程在O°~52°及52°~62°范围内分别采用了等加速——等速合理拼接运动规律。回程在62°~153°范围内采用了正弦加速度运动规律。用极坐标矢量分析法建立方程、微分,通过电脑程序计算,设计制造出凸轮轮廓,用于禾苗移植机的擒纵机构处,完全符合生产要求,获得了理想的效果。  相似文献   
4.
从刚落下的丝片上摇取小绞丝,分别在25—180℃和30、60、90min下进行干热处理后,测定其机械性能。结果表明:在90—100℃、30—60分钟时,生丝的强伸力、初始模量以及抱合等机械性能都较好,烘丝温度太高,时间太长都会对生丝机械性能产生不良的影响。  相似文献   
5.
在预备试验的基础上,选用了21种促进种子发芽的方法,结果显示,完整的s.aurantiaca种子对任何处理都无响应,砂纸磨擦 近胚根处切除小部分可使种子发芽率提高至11%。以上处理结合300mg/L GA3溶液的使用可破除种子休眠,使种子发芽率提高到69%以上。结果还表明,S.aurantiaca种子发芽的适宜温度为20℃;25℃ 16h/d光照及30℃的条件可降低种子的发芽率。研究还对S.aurantiaca种子的吸胀能力以及所含抑制物对生菜种子发芽的影响进行了比较。初步得出,S.aurantiaca种子具有种皮限制和种胚休眠的双重休眠机制,GA3和机械处理的相互作用可破除种子休眠。  相似文献   
6.
This experiment was conducted to determine the effect of ruminal dosing of a mechanical stimulating brush on rumination time, ruminal passage rate and rumen fermentation status in steers fed a concentrate diet at maintenance level. Animals were dosed three Rumen Faibu (RF) per head through the rumen fistulae (RF treatment) and not dosed (control) in a change‐over design. The organic cell wall content of the concentrate diet was 12.7% of dry matter. Daily time spent on rumination was very short in both treatments with 24 min in RF treatment and 15 min in control. The turnover rate of ruminal fluid in RF treatment was higher than that in control. There were no differences in ruminal pH and total volatile fatty acid concentration between RF treatment and control. Acetic and butyric acid concentrations were not different between the treatments. Propionic acid concentration tended to be higher in the animals on RF treatment than in control animals. The RF dosing in Holstein steers fed a low fiber diet did not affect the rumination time, but increased rumen digesta passage rate and ruminal propionic acid production.  相似文献   
7.
牛腔前卵泡的简易机械分离方法   总被引:9,自引:0,他引:9  
采用两种机械法分离牛腔前卵泡。方法一 (M -1) ,皮肤移植刀切割、剪碎、过滤镜下直接捡卵法。方法二 (M -2 ) ,皮质片剪碎、离心、悬浮、过滤镜下捡卵法。M -1平均每卵巢采卵数为 46 9个± 18 2个 ,M -2为 6 8 4个± 12 5个 ;处理时间M -1为 2 5 4min± 6 7min ,M -2为 46 3min± 16 8min ,两种方法采集腔前卵泡数量及处理时间均存在显著差异。平均每小时采集卵泡数分别为 99 5和 87 2个 ,M -1多于M -2。两种方法获得腔前卵泡大小分布规律也有明显差异 ,M -1采集腔前卵泡直径为 6 0~ 15 0 μm ,绝大部分是次级卵泡 ,而M -2获取腔前卵泡则偏小。总的看来 ,M -1处理时间短 ,回收效率高 ,方法简便 ,且分离卵泡直径较大 ,适于体外培养 ,是机械分离牛腔前卵泡的一种理想方法。  相似文献   
8.
采用专门设计的生物材料试验机测定了茶树新梢的折断力、断裂挠度和弹性模量等力学指标,初步探明了新梢节位(嫩度)、截面积、品种和空气温、湿度对这些指标的影响。结果表明折断式采摘机构能有效地实现选择性采茶,可克服切割式采茶机“一刀切”的弊端。此外,作者根据大量的测试数据,提出了折断式采摘器的基本工作参数。  相似文献   
9.
Field studies were undertaken to explore the weed management strategies for transplanted and direct wet-seeded rice in the Dera Ismail Khan district of North-west Frontier Province, Pakistan. The experimental design was a randomized complete block with a split plot arrangement. The main plots consisted of two planting techniques (transplantation and direct seeding), while weed control practises assigned to the subplots included the use of the granular herbicide Sunstar 15WG (ethoxy sulfuron), Machete 60EC (butachlor), conventional hand weeding, and the weedy check (untreated control). Data were recorded on weed dynamics and the agronomic parameters of the rice crop. Economic analyses on the data were also run. The weed density and biomass were lower in the transplantation plots than the direct-seeding plots. The herbicides ethoxy sulfuron and butachlor reduced the density over the weedy check, with a density comparable to hand weeding in 2002, but slightly higher in 2003. As a result of weed management by hand weeding and herbicides, the paddy yield and its components were significantly higher for the transplanted method compared to the direct-seeded method. The comparable yield of herbicides with hand weeding offers an option for the use of herbicides as an alternative management tool. In light of our findings, it is concluded that for good economic returns, rice crops may be transplanted rather than direct-seeded. The herbicides ethoxy sulfuron and butachlor offer a weed control cover comparable with hand weeding under the transplantation method, while butachlor is good for controlling weeds even under the direct-seeded conditions in the agroclimatic conditions of the area.  相似文献   
10.
不同粘度矿物油助剂对除草剂活性的影响   总被引:5,自引:1,他引:5  
室内及温室内测定了10种不同粘度矿物油助剂对除草剂防除苘麻和稗草药效的影响及对玉米苗期的安全性。结果表明,10种矿物油助剂均不同程度地增加了氰草津和烟嘧磺隆防除两种杂草的活性。其中粘度为46 mm2/s (40℃)的矿物油乳剂(MOC46)对供试除草剂药效的增强作用最为明显,其次为粘度32 mm2/s (40℃)的矿物油乳剂。10种助剂对氰草津药效的增强作用大于对烟嘧磺隆。MOC46对除草剂活性的增加由高到低依次为:莠去津、氰草津>莠去津+氰草津、莠去津+烟嘧磺隆、氰草津+烟嘧磺隆>烟嘧磺隆;对玉米苗期安全性依次为:莠去津、烟嘧磺隆、莠去津+烟嘧磺隆>莠去津+氰草津、氰草津+烟嘧磺隆>氰草津。氰草津与MOC46混用对玉米苗期药害较重。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号