首页 | 本学科首页   官方微博 | 高级检索  
     检索      

动边界同心环状缝隙流研究
引用本文:李永业,孙西欢,李飞,张靖伦.动边界同心环状缝隙流研究[J].农业机械学报,2012,43(3):230-234.
作者姓名:李永业  孙西欢  李飞  张靖伦
作者单位:太原理工大学水利科学与工程学院,太原,030024
基金项目:国家自然科学基金资助项目(51179116);国家杰出青年科学基金资助项目(51109155)
摘    要:为完善同心环状缝隙流理论,采用理论分析与模型试验相结合的方法,分析了圆柱体从静止到起动再到运行过程中同心环状缝隙流速的分布特点。得出圆柱体的速度、缝隙宽度以及流量对环状缝隙流的分布和大小的影响。环状缝隙流速随缝隙宽度的增大呈现先增大后减小的趋势,缝隙宽度约在2 cm附近时,缝隙流速最大;流量越大,环状缝隙流速就越大;圆柱体的速度越大,缝隙流速也越大;环状缝隙流速在与管内水流速度和圆柱体速度相交之前最大,相交之后最小。同时建立了动边界条件下的同心环状缝隙流数学模型,计算结果与试验基本一致,最大相对误差不超过8.5%,说明该数学模型可行。

关 键 词:环状缝隙流  同心  动边界  流速

Cyclical Slit Flow of Concentricity under the Moving Boundary Condition
Li Yongye,Sun Xihuan,Li Fei and Zhang Jinglun.Cyclical Slit Flow of Concentricity under the Moving Boundary Condition[J].Transactions of the Chinese Society of Agricultural Machinery,2012,43(3):230-234.
Authors:Li Yongye  Sun Xihuan  Li Fei and Zhang Jinglun
Institution:Taiyuan University of Technology;Taiyuan University of Technology;Taiyuan University of Technology;Taiyuan University of Technology
Abstract:In order to perfect the theory on the cyclical slit flow of concentricity, the distribution features of the cyclical slit flow were analyzed from stopping to starting and to run procedure on the cylinder by a combination of theoretical analysis and model experiments. It is concluded that the speeds of the cylinders, the gap widths and the discharges have effect on the distribution and magnitude of the cyclical slit flow. The cyclical slit flow velocity increased firstly and then decreased as the gap width enlarged. When the gap width was about 2cm, the cyclical slit flow velocity reached a maximum. The larger the discharge was, the larger the cyclical slit flow velocity would be. The larger the speed of the cylinder was, the larger the cyclical slit flow velocity would be. The cyclical slit flow rate increased to the maximum before the speed of the cylinder, the cyclical slit flow rate and the water velocity in the pipe intersect decreased to the minimum after that. Meanwhile mathematical model of the cyclical slit flow of concentricity under the moving boundary condition was established. The calculated values and experimental values are in substantial agreement and maximum relative error is no more than 8.5%, which showed the mathematical model is rational.
Keywords:Cyclical slit flow  Concentricity  Moving boundary  Flow velocity
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《农业机械学报》浏览原始摘要信息
点击此处可从《农业机械学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号