首页 | 本学科首页   官方微博 | 高级检索  
     检索      

响应面法优化亚麻纤维/聚乳酸复合材料的制造工艺
引用本文:张一鸣,袁媛,郭明辉.响应面法优化亚麻纤维/聚乳酸复合材料的制造工艺[J].东北林业大学学报,2012,40(8):86-89.
作者姓名:张一鸣  袁媛  郭明辉
作者单位:东北林业大学,哈尔滨,150040
基金项目:“十二五”国家科技支撑计划项目,黑龙江省重点科技攻关项目
摘    要:以聚乳酸纤维为基本相,亚麻纤维为增强体,通过层结构铺装热压制得亚麻纤维/聚乳酸复合材料。通过单因素试验分析了各因素对复合材料力学性能的影响,确定了各因素试验范围。利用响应面法确定出最优的工艺参数:亚麻用量43%,硅烷用量4%,热压温度190℃。按照此工艺条件制造的复合材料的拉伸强度、拉伸模量、弯曲强度和弯曲模量分别为49.70 MPa、3.12 GPa、33.50 MPa和2.34 GPa。

关 键 词:响应面法  亚麻纤维  聚乳酸  硅烷  复合材料  制造工艺

Manufacturing Process of Flax Fibers/Polylactic Acid Composites Based on Response Surface Methodology
Zhang Yiming , Yuan Yuan , Guo Minghui.Manufacturing Process of Flax Fibers/Polylactic Acid Composites Based on Response Surface Methodology[J].Journal of Northeast Forestry University,2012,40(8):86-89.
Authors:Zhang Yiming  Yuan Yuan  Guo Minghui
Institution:(Key Laboratory of Bio-based Material Science and Technology(Northeast Forestry University),Ministry of Education,Harbin 150040,P.R.China)
Abstract:Film stacking and hot pressing techniques were applied to produce flax fibers(FF)/polylactic acid(PLA) compo-sites using PLA film as basic phase and FF as reinforcement.The relationships between the main process parameters and the performances of the composites were analyzed by single-factor experiments in order to determine the range of the experimental factors.The optimal parameters were determined by the response surface methodology as flax addition 42%,silane addition 4%,and hot-pressing temperature 190 degrees C.The tensile strength,tensile modulus,flexural strength,and flexural modulus of the composites under the optimal process conditions were 49.70 MPa,3.12 GPa,33.50 MPa,and 2.34 GPa,respectively.
Keywords:Response surface methodology  Flax fibers  Polylactic acid  Silane  Composites  Manufacturing process
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号