首页 | 本学科首页   官方微博 | 高级检索  
     检索      

导热油加热的连续热压干燥机干燥速生杨单板的应用研究
引用本文:顾炼百,李大纲,陆肖宝,承国义.导热油加热的连续热压干燥机干燥速生杨单板的应用研究[J].林产工业,2000,27(1):17-19.
作者姓名:顾炼百  李大纲  陆肖宝  承国义
作者单位:南京林业大学,南京,210037
基金项目:“九五”国家科技攻关专题!96-011-02-06
摘    要:导热油作载热体,在速生杨木单板连续式热压干燥中应用后,效果良好。美洲黑杨生材单板(名义厚度1.7mm)可在2min内于至8%以下的含水率。干单板基本平整、光滑,终含水率均匀,无撕裂。单板厚度干缩率平均5.3%,横纹干缩率4.9%。胶合强度平均0.812MPa,略高于网带对流干燥单板胶合强度0.779MPa。研究结果表明,此法干燥速生杨木单板是可行的。

关 键 词:导热油  杨木单板  连续式热压干燥机  干缩  撕裂
修稿时间:1999-08-09

Application Research of Heat-Conducting Oil in Continuous Platen Drying of Fast Growing Popular Veneer
Gu Lianbai,Li Dagang,Lu Xiaobao,Cheng Guoyi.Application Research of Heat-Conducting Oil in Continuous Platen Drying of Fast Growing Popular Veneer[J].China Forest Products Industry,2000,27(1):17-19.
Authors:Gu Lianbai  Li Dagang  Lu Xiaobao  Cheng Guoyi
Institution:Gu Lianbai ,Li Dagang ,Lu Xiaobao ,Cheng Guoyi ;(Nanjing Forestry University, Nanjing 210037)
Abstract:Heat-conducting oil was used as a heat-carrier in continuous platen drying of fast-growing popular veneer and achieved good results. Cottonwood green veneer(nominal thickness of 1.7mm)was dried to moisture content(MC)of below 8% in 2 minutes. The dried veneer was basically flat and smooth with evenfinal MC and no split. The thickness shrinkage of the veneer was average 5.3% ,and the cross-grain shrinkage 4.9%. The bonding strength of the veneer was average 0.812MPa slighrly higher than 0.779MPa of veneer dried by convection drier with net conveyer. The research results show that drying veneer of fastgrowing poplar with the above method is feasible.
Keywords:Heat-conducting oil  Cottonwood veneer  Continuous platen drying  Drying shrinkage  Split
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号