| 聚氨酯橡胶胀形模设计 |
| |
| 引用本文： | 周钢,陈建山,曾旭辉,吴宇雄.聚氨酯橡胶胀形模设计[J].中南林学院学报,2005,25(6):152-154. |
| |
| 作者姓名： | 周钢 陈建山 曾旭辉 吴宇雄 |
| |
| 作者单位： | [1]中南林学院工业学院,湖南长沙410004 [2]南方动力机械公司摩托车制造厂,湖南株洲412002 |
| |
| 基金项目： | 中南林学院青年科技基金资助项目“聚氨酯橡胶胀形模设计”（101-0046）. |
| |
| 摘 要： | 在生产中大型制件胀形模，由于材料拉伸变形较大，往往导致制件开裂、起皱等问题．小型制件采用聚氨酯橡胶制造胀形模已得到了应用，以此为基础，对摩托车油箱这种较大零件的胀形模进行改进，用聚氨酯橡胶代替原钢制凸模，很好地解决了零件出现的缺陷，在生产中已获得了成功并投入使用．
|
| 关 键 词： | 聚氨酯 橡胶 摩托车油箱 模具 胀形模 |
| 收稿时间： | 01 25 2005 12:00AM |
The Design of Polyurethane Rubber Expansion Mould |
| |
| ZHOU Gang,CHEN Jian-shan, ZENG Xu-hui, WU Yu-xiong.The Design of Polyurethane Rubber Expansion Mould[J].Journal of Central South Forestry University,2005,25(6):152-154. |
| |
| Authors: | ZHOU Gang CHEN Jian-shan ZENG Xu-hui WU Yu-xiong |
| |
| Institution: | 1. School of Industry Technology of Central South Forestry University, Changsha 4100041 Hunan, China; 2. China South Air-engine Machinery Co. , Motorcycle Plant, Zhuzhou 412002, Hunan, China |
| |
| Abstract: | Cracks, golfers and other defects often occurred in large work-piece products by expansion mould due to the big tensile deformation. Polyurethane rubber expansion mould has been put into use in the small work-piece production. Motorcycle fuel tank, as a large work-piece, is always produced by steel mould and has the above defects. In this study, great modification of expansion mould of motorcycle tank has been made to solve the defects problem. Polyurethane rubber has replaced the steel convex mould of motorcycle fuel tank. The new design of polyurethane rubber expansion mould has successfully been applied. |
| |
| Keywords: | polyurethane resin rubber motorcycle oil tank mould expansion mould |
| 本文献已被 维普 等数据库收录！ |
|
