排序方式： 共有7条查询结果，搜索用时 15 毫秒
1
1.
2.
OBJECTIVE: To compare the mechanical properties of 4 stabilization methods for equine long-bone fractures: dynamic compression plate (DCP), limited contact-DCPlate (LC-DCP), locking compression plate (LCP), and the clamp-rod internal fixator (CRIF--formerly VetFix). STUDY DESIGN: In vitro mechanical study. SAMPLE POPULATION: Bone substitute material (24 tubes) was cut at 20 degrees to the long axis of the tube to simulate an oblique mid-shaft fracture. METHODS: Tubes were divided into 4 groups (n=6) and double plated in an orthogonal configuration, with 1 screw of 1 implant being inserted in lag fashion through the "fracture". Thus, the groups were: (1) 2 DCP implants (4.5, broad, 10 holes); (2) 2 LC-DCP implants (5.5, broad, 10 holes); (3) 2 LCP implants (4.5/5.0, broad, 10 holes) and 4 head locking screws/plate; and (4) 2 CRIF (4.5/5.0) and 10 clamps in alternating position left and right of the rod. All constructs were tested in 4-point bending with a quasi-static load until failure. The implant with the interfragmentary screw was always positioned on the tension side of the construct. Force, displacement, and angular displacement at the "fracture" line were determined. Construct stiffness under low and high loads, yield strength, ultimate strength, and maximum angular displacement were determined. RESULTS: None of the implants failed; the strength of the bone substitute was the limiting factor. At low loads, no differences in stiffness were found among groups, but LCP constructs were stiffer than other constructs under high loads (P=.004). Ultimate strength was lowest in the LCP group (P=.01), whereas yield strength was highest for LCP constructs (409 N m, P=.004). CRIF had the lowest yield strength (117 N m, P=.004); no differences in yield strength (250 N m) were found between DCP and LC-DCP constructs. Differences were found for maximum angular displacement at the "fracture" line, between groups: LPC相似文献
3.
Arnold C. Grosscurt Martin Ter Haar Berend Jongsma Andries Stoker 《Pest management science》1988,22(1):51-59
PH 70–23 is a new benzoylphenylurea interfering with chitin deposition. In larvae of Spodoptera littoralis, incorporation of N-acetyl-glucosamine into chitin was equally inhibited by PH 70–23 and diflubenzuron, the first commercially available benzoylphenylurea. In contrast to diflubenzuron, which is active only against insects and eriophyid mites, PH 70–23 has the advantage of also being highly active on spider mites. The latter activity might be partly due to leaf penetration of PH 70–23. Laboratory experiments indicate PH 70–23 to have a better ovo-larvicidal activity than the commercial acaricides tested (cyhexatin, dicofol, fenbutatin oxide and tetradifon) against Tetranychus cinnabarinus, T. turkestani, T. urticae and Panonychus ulmi. A method in which eggs were deposited on residues of cyhexatin or fenbutatin oxide resulted in much lower activities than application of the spray liquid after egg deposition. Activities of PH 70–23, dicofol and tetradifon were hardly influenced by this difference in the test method. The direct contact activity of PH 70–23 on eggs of mites is influenced by the relative humidity and the age of the eggs. The total ovolarvicidal activity of PH 70–23 is only slightly positively influenced by the relative humidity, however. Ovicidal activity of PH 70–23 is also achieved by transovarial transmission. The compound does not influence the fertility of the mites. Comparison of a strain of T. urticae, resistant to dicofol, parathion and tetradifon, with a susceptible strain indicated absence of cross-resistance to PH 70–23. Compared to diflubenzuron, PH 70–23 shows an interesting shift in the spectrum of insecticidal activity. 相似文献
4.
Cecilia A.M. Sandström Anita G.J. Buma Bethany J. Hoye Jouke Prop Henk van der Jeugd Berend Voslamber Jesper Madsen Maarten J.J.E. Loonen 《Veterinary parasitology》2013
Toxoplasma gondii is an intracellular coccidian parasite found worldwide and is known to infect virtually all warm-blooded animals. It requires a cat (family Felidae) to complete its full life cycle. Despite the absence of wild felids on the Arctic archipelago of Svalbard, T. gondii has been found in resident predators such as the arctic fox and polar bear. It has therefore been suggested that T. gondii may enter this ecosystem via migratory birds. The objective of this study was to identify locations where goose populations may become infected with T. gondii, and to investigate the dynamics of T. gondii specific antibodies. Single blood samples of both adults and juveniles were collected from selected goose species (Anser anser, A. brachyrhynchus, Branta canadensis, B. leucopsis) at Arctic brood-rearing areas in Russia and on Svalbard, and temperate wintering grounds in the Netherlands and Denmark (migratory populations) as well as temperate brood-rearing grounds (the Netherlands, non-migratory populations). A modified agglutination test was used on serum, for detection of antibodies against T. gondii. Occasional repeated annual sampling of individual adults was performed to determine the antibody dynamics. Adults were found seropositive at all locations (Arctic and temperate, brood-rearing and wintering grounds) with low seroprevalence in brood-rearing birds on temperate grounds. As no juvenile geese were found seropositive at any brood-rearing location, but nine month old geese were found seropositive during spring migration we conclude that geese, irrespective of species and migration, encounter T. gondii infection in wintering areas. In re-sampled birds on Svalbard significant seroreversion was observed, with 42% of seropositive adults showing no detectable antibodies after 12 months, while the proportion of seroconversion was only 3%. Modelled variation of seroprevalence with field data on antibody longevity and parasite transmission suggests seroprevalence of a population within a range of 5.2–19.9%, in line with measured values. The high occurrence of seroreversion compared to the low occurrence of seroconversion hampers analysis of species- or site-specific patterns, but explains the absence of an increase in seroprevalence with age and the observed variation in antibody titre. These findings imply that even though infection rate is low, adults introduce T. gondii to the high Arctic ecosystem following infection in temperate regions. 相似文献
5.
OBJECTIVE: To compare the gripping force of a standard clamp with click-on and T clamps of the 4.5/5.5-mm VetFix (AO Research Institute, Davos, Switzerland), mounted on smooth and roughened rods. STUDY DESIGN: In vitro mechanical study. METHODS: Rods were mounted on a clamp-holding device. Each clamp type was tested on a materials-testing machine in groups of 6 specimens for torsional and axial load stability on smooth and roughened rods (total, 72 specimens). The variable evaluated was the discontinuity point (DP) as a measure for gliding resistance of the clamp on the rod. Means (+/-SD) were calculated for all groups separately. For statistical comparison, a multiple regression model was fitted with level of significance set at P =.05. RESULTS: The direction of torsion had a significant effect on DP for both asymmetric clamps (standard, click-on). In torsion and axial load, the roughened rod had significantly higher DP levels than the smooth rod for the standard clamp. Rods differed only in axial load for the T clamp, again favoring the roughened rod. The click-on clamp did not reach 10% of the values achieved by the other clamps, independent from the rods and loading conditions. Compared with the T clamp, standard clamp DP values were significantly higher in torsion on the roughened rod as well as in axial load on both rod types. CONCLUSIONS: The roughened rod with a standard clamp was mechanically superior. For the T clamp, the small loss of gripping force may be compensated for by the possibility of inserting 2 more screws. CLINICAL RELEVANCE: The roughened rod may enhance the bending, compressive, and torsional properties of the 4.5/5.5-mm VetFix system by reducing the risk of clamp gliding on the rod. The standard clamp is the clamp of choice, except for the metaphyseal or epiphyseal region, at which use of a T clamp may be indicated to increase the number of screws inserted at the end of the rod. 相似文献
6.
Ciccarelli FD Doerks T von Mering C Creevey CJ Snel B Bork P 《Science (New York, N.Y.)》2006,311(5765):1283-1287
We have developed an automatable procedure for reconstructing the tree of life with branch lengths comparable across all three domains. The tree has its basis in a concatenation of 31 orthologs occurring in 191 species with sequenced genomes. It revealed interdomain discrepancies in taxonomic classification. Systematic detection and subsequent exclusion of products of horizontal gene transfer increased phylogenetic resolution, allowing us to confirm accepted relationships and resolve disputed and preliminary classifications. For example, we place the phylum Acidobacteria as a sister group of delta-Proteobacteria, support a Gram-positive origin of Bacteria, and suggest a thermophilic last universal common ancestor. 相似文献
7.
Haerdi-Landerer C Steiner A Linke B Wahl D Schneider E Hehli M Frei R Auer JA 《Veterinary surgery : VS》2002,31(6):582-588
OBJECTIVE: To compare the mechanical properties of 2 configurations of a veterinary fixation system (VFS) for large animal long bones with dynamic compression plating (DCP). SAMPLE POPULATION: Eighteen pairs of Canevasit tubes (Canevasit; Amsler und Frei, Schinznach Dorf, Switzerland) (length, 170 mm; diameter, 47.5 mm; cortex thickness, 10 mm), aligned with a 10-mm gap, and stabilized with 2 DCP or 2 VFS implants. METHODS: Three groups (n = 6) were compared. Group 1 Canevasit tubes were stabilized with two 10-hole, broad 4.5-mm stainless steel DCP applied with both plates centered over the gap, in orthogonal planes parallel to the long axis of the tubes and staggered to allow bicortical fixation with ten 4.5-mm, 52-mm-long cortex screws each. Group 2 tubes were stabilized similarly with 2 VFS implants, each composed of a stainless steel rod (length, 167 mm; diameter, 8 mm), and 10 clamps were applied in alternating fashion left and right on the rod and fixed bicortically with ten 4.5-mm, 52-mm-long, cortex screws. Group 3 tubes were stabilized similarly, but using only 6 clamps/rod. All groups were tested initially in torsion within elastic limits and subsequently in 4-point bending, with 1 implant on the tension side, until gap closure occurred. RESULTS: None of the constructs failed, but all had plastic deformation after 4-point bending. No statistically significant differences were found among the 3 groups in torsional stiffness. Double DCP fixation was significantly stiffer and stronger in 4-point bending, compared with both configurations of double VFS fixation. CONCLUSIONS: The plate design was favored in this study. The VFS system may have to be adapted before further tests are conducted. Test modalities have to be chosen closer to clinical conditions (real bone, cyclic loading, closed gap). CLINICAL RELEVANCE: The veterinary fixation system has not yet proven its advantages for large animal long bone fracture repair. From the pure mechanical point of view, double DCP is the favored method for the treatment mentioned. 相似文献
1